NuMaker-ML51SD
1. | Install the preferred toolchain. Please make sure at least one of the toolchains has been installed. | ||||
- | KEIL C51 | ||||
- | IAR EW8051 | ||||
2. | Download and install the latest Nuvoton Nu-Link Driver. Please install the Nu-Link USB Driver as well at the end of the installation. | ||||
- | Download and install Nu-Link_Keil_Driver when using Keil C51. | ||||
- | Download and install Nu-Link_IAR_Driver when using IAR EW8051 | ||||
3. | Download and unzip the Board Support Package ( BSP ). | ||||
- | Download and unzip ML51_Series_BSP_Keil when using Keil C51. | ||||
- | Download and unzip ML51_Series_BSP_IAR when using IAR EW8051 | ||||
4. | Hardware Setup | ||||
(1) Open the virtual COM ( VCOM ) function by changing Nu-Link2-Me VCOM Switch No. 1 and 2 to ON. | |||||
|
|||||
(2) Connect the ICE USB connector to the PC USB port through USB cable. | |||||
|
|||||
(3) Find the “Nuvoton Virtual COM Port” at Device Manger. | |||||
|
|||||
5. | Use the “Template” project as an example. The project can be found under the BSP folders. | ||||
- | ML51_BSP_Keil_C51_V2.XX.XXX | ||||
- | SampleCode | ||||
- | Template | ||||
- .KEIL | |||||
6. | Open and execute the project under the toolchain. For detail setting, please refer to the NuMaker-ML51SD User Manual. | ||||
7. | User can see the result in the ternimal window on PC. | ||||
|
|||||
Resources |
|||||
User Manual | Microcontrollers | Software Development Tool | Driver (BSP) | Programmer | Nuvoton Official Forum | Nuvoton eStore
*Ordering Number : NK-ML51SD |